123.HP.COM/SETUP 8710 – INK CARTRIDGE REPLACEMENT

Ink replacement is a routine task if you are consistently using your Officejet 8710 printer. In that case, you can make use of the tutorial given here to accomplish the ink replacement without much hassles.

First, remove the cartridge

In order to install a new cartridge into your Officejet 8710 printer, you will have to remove the existing cartridges. The following set of steps will help you perform the 123.hp.com/setup 8710 ink replacement,

  • First, switch on your printer and make sure it has a paper in the paper tray

  • There is a cartridge access door on the front side which should then be opened

  • Wait until the cartridge comes to the center after moving from the side

  • Once the sounds have stopped, give a little force and remove it from the socket

You can either discard the cartridge or send it to HP for refurbishment

NOTE: A brand new one will always cost you more when compared to a refurbished cartridge; make a decision accordingly

Second, insert the cartridge

Except for the part where you have to remove the protective packing materials, the following set of steps are common for both new cartridges as well as refurbished ones

  • Remove orange clips and tapes from the replacement

  • Begin to insert the cartridge assuming that you have the cartridge access door still open

  • Insert the cartridge into its specified slot with a gentle push with the copper side facing back

  • Once the cartridge is in its right place you will hear a small snapping sound

  • Replace all the cartridges if necessary

For assistance or help in this process, feel free to give us a call at our toll-free number +1-844-876-5110.